Lexmark 258x - Manual (Page 12)

SIC Command
1-6
Draft document
Table 1-5: Ids - Dec 197, 198 (Hex C5, C6) (Sheet 1 of 9)
Parm Description Dec Hex Action for Id = Dec 197 / Hex C5 Action for Id = Dec 198 / Hex C6
1 Emulation 0 00 No Change No Change
1 01 PPDS PPDS
2 02 EPSON EPSON
3 - 255 03 - FF No Change No Change
2 Panel Disable 0 00 No change No change
1 01 Panel Disable Panel Disable
2 02 Panel Enable Panel Enable
Note: Specific buttons can be enabled during Panel Disable mode. The upper 6 bits of parm 2 represent the different buttons
on the operator panel as below.
Bit OFF ON
7. Font Disabled Enabled
6. Pitch Disabled Enabled
5. Micro up Disabled Enabled
4. Micro down Disabled Enabled
3. LF Disabled Enabled
2. Macro Disabled Enabled
3 Macro 0 00 No change No change
1 01 Macro 1 Macro 1
2 02 Macro 2 Macro 2
3 03 Macro 3 Macro 3
4 04 Macro 4 Macro 4
5 - 254 05 - FE No Change No Change
255 FF Disable Macro Disable Macro
Notes:
• Macro 1 is the original macro that is backward compatible. Macros 2-4 were added to provide additional flexibility when
changing between alternate form sizes. Disable macro is functionally the same as Macro 1.
If init = dec 4, 5 (hex 04, 05) are specified, parm 3 is ignored.
If init = dec 0, 1, 254, 255 (hex 00, 01, FE, FF) are specified, parm 3 value is used as Macro No. instead of Default Macro
setting No.
If init = dec 254, 255 (hex FE, FF) are specified, parm 3 value is overwritten to Default Macro setting in NVRAM. If the
disable (=255) is set to parm 3 Macro No. 1 setting is used to initialize.
• “No change” indicates the printer will retain the current macro. All parameters will overwrite the NVRAM of the current
macro.