Lexmark 258x - Manual (Page 47)

Style Commands
2-27
Draft document
Select Print Type Style
This command selects the following printing modes:
•
Character height - single or double
•
Character width - single or double
•
Line Spacing - single or double
•
Italic print
•
Shadow print (259x only)
•
Outline print (259x only)
USAGE NOTES
•
n1 and n2 specify the number of mode bytes contained in this escape
sequence. Normally, n1 is 4, and n2 is 0.
•
Normally, m2 is 0 (Dec) 00 (Hex). (Not supported)
•
m1 controls start and stop of the character modes. See the table below for
values.
•
m3 controls line spacing and character height. It as two parts: a high-order
half-byte and a low-order half-byte. The high-order half-byte of m3 controls
the line spacing and the low-order half-byte controls the character height. See
the table below for values.
•
m4 controls the character width. Only the low-order half-byte is significant in
this mode byte. The high-order half-byte is ignored. See the table below for
values.
Format ESC [ @ n1 n2 m1 m2 m3 m4
Decimal 27 91 64 n1 n2 m1 0 m3 m4
Hexadecimal 1B 5B 40 n1 n2 m1 00 m3 m4