Lennox Hearth PB42 - Manual (Page 23)

PB42 Portable Receipt Printer User’s Guide 23
Printing a Configuration Test Page
After you have loaded the media in the printer, you are ready to
print out the configuration test page. Use this information for
reference when installing your PB42 and to verify proper printer
operation. If you cannot get the configuration test page to print,
see “Troubleshooting” on page 30 for help.
To print the configuration test page
• Press and hold the Feed and Radio buttons until the printer
emits the Button sound and the page starts to print.
The printer prints out a configuration test page containing
information about the printer configuration, the wired
configuration, the wireless configuration and the fonts and
graphics available on the printer.
-Intermec PB42 Printer Configuration-
Serial Number : 12345678901
Firmware : PB42F3932_032806 (Ver 3.32)
Hardware : RevA-001, Flash 4MB, Ram 16MB
Batteries : #1 8.5V #2 8.5V
Low Battery Indicator: 6.6V
Dark Adjust : Level 4 (0%)
Emulation : PB42_REL2
Temperature : 34C
Allow Messages from Printer: Off
Wired (RS-232) Configuration:
Baud Rate : 115200
Parity : None
Data Bits : 8
Stop Bits : 1
Flow Control : Hardware
Example of Printer and Serial Port Configuration Settings