LSI SATA 150 - Manual (Page 34)

3-4 SATA 150 Storage Adapter Characteristics
Copyright © 2002–2006 by LSI Logic Corporation. All rights reserved.
3.1.2 MegaRAID SATA 150-4
The MegaRAID SATA 150-4 is an intelligent RAID controller that
provides four Serial ATA ports and supports RAID 0, RAID 1, RAID 5,
and RAID 10 arrays. The SATA 150-4 does the following:
•
Supports four Serial ATA channels:
– Uses differential signaling
– Transfers data in frames
– Supports Serial ATA power management
•
Complies with the PCI 2.2 Specification
•
Supports up to a 64-bit/66 MHz PCI interface:
– Functions in a 64-bit PCI slot
– Functions at 66 MHz or 33 MHz
– Supports 3.3 V and 5.0 V PCI signaling
– Is backward compatible with previous versions of the PCI
specification
The MegaRAID configuration utility and the WebBIOS utility provide
RAID management and configuration support before the operating
system boots. The MegaRAID Manager tool and the Power Console Plus
tool provide RAID management and configuration support after the
J6 I 2 C connector, used as the interface for the
controller to communicate with a storage
enclosure processor
Open
J7-J12 Port connectors (see Figure 3.1 for details) Optional
J13 Enables Mode 0 Select Open
J14 Enables 3.3 V load sharing from motherboard Optional
J15 Battery backup daughter card connector Optional
J16, J17,
JP1
Reserved for internal use –
Table 3.2 SATA 150-6 Connector and Jumper Description (Cont.)
Jumpers
and
Connectors Description Setting