Lux Products TX9000TS - Manual (Page 2)

DAY OF
WEEK
TIME
PROGRAM PERIOD
TEMPERATURE
MODE SWITCH
LIGHT
BUTTON
FAN SWITCH
1. FEATURES
• Extra Large Hybrid Touch Screen Display
• Audible Touch Confirmation
• EL Display Illumination
• Elegant Design
• 7 Day Programming
• Energy Star
® Compliant
• 4 Periods Per Day
• Battery Free Memory For All Programs And
Settings
• Temporary Temperature Override
• Temperature Hold
• Keyboard Lockout
• F/C Temperature Display
• 12/24 Hr Clock Display
• Adjustable Temperature Differential / Cycle Rate
• Temperature Calibration
• 5/2 minute selectable minimum Run/Off time
provides short cycle and compressor protection
CAUTION:
• The TX9000TS is protected against normal static
electric discharges. However, in extremely dry weather
you should touch a grounded metal object before the
TX9000TS to minimize the risk of causing damage to the
unit.
• Your thermostat is a precision instrument. Please
handle it with care.
2. COMPATIBILITY
The TX9000TS can be used with most 24 volt gas,
oil or electric heating and air conditioning systems,
single stage heat pumps or gas millivolt heating
systems. It cannot be used with 3 wire zone
valves, 120V systems, or multistage systems.
Ask your dealer for other LUX thermostats to
control those systems.
3. INSTALLATION
Please read all instructions carefully before
beginning installation.
WARNING:
• Your thermostat is a precision instrument. Please
handle it with care.
• All wiring must conform to local codes and
ordinances.
• Turn off electricity to the appliance before installing or
servicing thermostat or any part of the system. Do not
turn electricity back on until work is completed.
• This thermostat is designed for use with 24 volt and
millivolt systems. The thermostat should be limited to a
maximum of 1.5 amps; higher amperage may cause
damage to the thermostat.
• Do not short (jumper) across electric terminals at
control on furnace or air conditioner to test the system.
This will damage the thermostat and void your warranty.
3.1. TOOLS REQUIRED
● #1 Phillips screwdriver (small)
● Drill with 3/16-in. (4.8mm) bit
● Wire stripper/cutter
3.2. LOCATION
On replacement installations, mount the new
thermostat in place of the old one unless the
conditions listed below suggest otherwise. On new
installations, follow the guidelines listed below.
• Locate the thermostat on an inside wall, about 5
ft. (1.5m) above the floor, in a room that is used
often.
2
TX9000TS