Operation, Warning – Lincoln Electric WELD-PAK 3200HD User Manual

Page 18

Advertising
background image

B-4

OPERATION

B-4

Friction Brake Adjustment

With wire spool installed on the spindle shaft and the
wing nut loose, turn the spool by hand while slowly
tightening the wing nut until a light drag is felt. Tighten
the wing nut an additional 1/4 turn.

Note:

When properly adjusted, the brake should pro-

vide only enough drag to prevent overrun of the spool
and excess slack in the wire. Too much drag may
result in wire feeding problems, and may cause pre-
mature wear of wire drive system components.

Wire Threading

Refer to Figure B.4

1. Release the Spring Loaded Pressure Arm (1)

rotate the Idle Roll Arm (2) away from. the Wire
Feed Drive Roll (3). Ensure that the groove size in
the feeding position on the drive roll matches the
wire size being used.

2. Carefully detach the end of the wire from the

spool. To prevent the spool from unwinding,
maintain tension on the wire until after step 5.

3. Cut the bent portion of wire off and straighten the

first 4

(100 mm).

4. Thread the wire through the In-going guide tube

(4), over the drive roll (3), and into the out-going
guide tube (5).

5. Close the idle roll arm (2) and latch the spring

loaded pressure arm (1) in place. Rotate the spool
counterclockwise if required in order to take up
extra slack in the wire.

6. The idle roll pressure adjustment wing nut is factory

set to approximately five full turns from where the
wing nut first engages the threads of the pressure
arm (1). If feeding problems occur because the wire
is flattened excessively, turn the pressure adjust-
ment counter-clockwise to reduce distortion of the
wire. Slightly less pressure may be required when
using 0.023

0.025" (0,6 mm) wire. If the drive roll

slips while feeding wire, the pressure should be
increased until the wire feeds properly.

When inching the welding wire, the drive rolls, the
gun connector block and the gun contact tip are
electrically energized relative to work and ground
and remain energized for several seconds after
the gun trigger is released.

FIGURE B.4

7. Refer to Figure B.5. Remove gas nozzle and con-

tact tip from end of gun.

8. Turn the WELD-PAK 3200HD ON (

I

).

9. Straighten the gun cable assembly.

10. Depress the gun trigger switch and feed welding

wire through the gun and cable. (Point gun away
from yourself and others while feeding wire.)
Release gun trigger after wire appears at end of
gun.

11. Turn the WELD-PAK 3200HD OFF (

O

).

12. Replace contact tip and gas nozzle.

13. Refer to Figure B-6. Cut the wire off 1/4

” –

3/8

(6

10 mm) from the end of the tip. The WELD-PAK

3200HD is now ready to weld.

FIGURE B.5

WELD-PAK 3200HD

WARNING

The Wire Drive Feed Roll can
accommodate two wire sizes
by flipping the wire drive feed
roll over.

1

2

3

4

5

Gun Handle

Gas Diffuser/
Contact Tip

Gas Nozzle

Advertising
This manual is related to the following products: