Maintenance, Component replacement procedures, Caution – Lincoln Electric WELD-PAK 3200HD User Manual

Page 37

Advertising
background image

D-3

MAINTENANCE

D-3

WELD-PAK 3200HD

COMPONENT
REPLACEMENT
PROCEDURES

CHANGING THE CONTACT TIP

1. Refer to Figure D.2. Remove the gas nozzle from

the gun by unscrewing counter-clockwise.

2. Remove the existing contact tip from the gun by

unscrewing counter-clockwise.

3. Insert and hand tighten desired contact tip.

4. Replace gas nozzle.

CHANGING DRIVE ROLL

The drive roll has two grooves; one for .023" – .025"
(0.6 mm) solid steel electrode and a larger knurled
groove for .030" (0.8 mm) solid and .035" (0.9 mm)
flux-cored steel electrode. As shipped, the drive roll is
installed in the .030"/.035" (0.8/0.9 mm) position.

If .023" – .025" (0.6 mm) wire is to be used, the drive
roll must be reversed as follows:

1. Connect the machine to its rated input power per

instructions in Installation section.

2. Release the spring-loaded idle arm tensioner Item 2, and

lift the idle roll arm, Item 3, away from the drive roll, Item
1. (See Figure D.1)

3. Turn the power switch to ON (marked “I”).

4. Set the wire speed to minimum and jog the drive

unit with the trigger switch until the drive roll set
screw is facing up.

When inching the welding wire, the drive rolls,
gun connector block, and gun contact tip are
energized relative to work and ground and remain
energized for several seconds after the gun trig-
ger is released.

5. Turn the power switch to OFF (marked “O”).

6. Loosen the drive roll set screw with the 5/64" (2.0

mm) hex wrench supplied.

7. Remove the drive roll, flip over and reinstall with the

.023 – .025" (0.6 mm) groove (the smaller groove)
closest to the gearbox.

8. Push a length of straightened welding wire through

the wire feeder guide tubes and adjust the position
of the drive roll so that the groove is centered on
the wire. Make certain the set screw is located on
the flat portion of the shaft and tighten.

3

2

1

FIGURE D.1

CAUTION

Advertising
This manual is related to the following products: