Pride Mobility JAZZY 1103 ULTRA - Manual (Page 25)

Jazzy 1103 Ultra www.pridemobility.com 25
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or backward to the desired position.
3. Release the lever.
Armrest Width Adjustment
You can change each armrest’s width independently of
the other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 16.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to
the floor. See figure 16.
2. Loosen the jam nut.
3. Turn the adjusting screw clockwise to raise the front of
the armrest, or turn the adjusting screw counterclock-
wise to lower the front of the armrest.
4. Tighten the jam nut to lock the adjusting screw into
place.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to different heights
in 1/2-in. increments.
To raise or lower the foot platform:
1. Remove the quick release fasteners from the foot
platform bracket. See figure 17.
2. Raise or lower the foot platform to the desired height.
3. Reinstall the quick release fasteners into the foot
platform bracket and tighten.
V . C O M F O R T A D J U S T M E N T S
Figure 17. Foot Platform Adjustment
Figure 18. Quick Release Fastener Operation
LEVER (OPEN)
BOLT
NUT
CAM
UNCLAMPED CLAMPED
LEVER (FULLY CLOSED)
Reclining Seat
If your power chair is equipped with a reclining seat, you
can adjust the seatback angle with the seatback release
lever. The lever is located on the right side of the seat
base. See figure 5.
QUICK RELEASE FASTENERS
FOOT PLATFORM BRACKET
FOOT PLATFORM
RETAINING PIN