Pride Mobility JAZZY 1103 ULTRA - Manual (Page 27)

Jazzy 1103 Ultra www.pridemobility.com 27
V . C O M F O R T A D J U S T M E N T S
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the
rear shroud.
3. Unplug the controller connectors from the power pod.
4. Cut the wire ties that attach the controller cable to
the armrest.
5. Locate the setscrew on the underside of the armrest.
See figure 20.
6. Slide the controller out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the controller in the other armrest.
9. Tighten the setscrew to secure the controller.
10. Route the controller connector to the back of the power
base and secure the controller cable to the armrest
receiver with wire ties.
11. Plug the controller connectors into the power pod. See
figure 7.
12. Reinstall the rear shroud and tighten the fasteners.
Swing-away Footrests
Swing-away Footrests (SFRs) enable you to rotate the foot-
rests to the side before you transfer onto or off or your
power chair.
To rotate the SFRs:
1. Push in the release lever. See figure 21.
2. Rotate the SFRs.
To adjust the SFR length:
1. Remove the two adjustment screws from the side of
each foot rest extension. See figure 21.
2. Slide the foot rest up or down to the desired length.
3. Reinstall the two adjustment screws.
Elevating Leg Rests
Elevating Leg Rests (ELRs) offer an infinite range of adjust-
ment for the leg angle and a footrest adjustment range of
12–19 in.
To rotate the ELRs:
1. Push in release lever A. See figure 22.
2. Rotate the ELRs.
ADJUSTMENT SCREWS
RELEASE LEVER B
Figure 22. Elevating Leg Rests
RELEASE LEVER A
LEG REST
EXTENSION
Figure 21. Swing-Away Footrests
ADJUSTMENT
SCREWS
FOOTREST
EXTENSION
SFR RELEASE LEVER