Pride Mobility JAZZY 1103 ULTRA - Manual (Page 51)

Jazzy 1103 Ultra www.pridemobility.com 51
V I I I . C A R E A N D M A I N T E N A N C E
17. Place a new battery in the front of the battery tray. Make sure that the terminals are facing each other.
WARNING! Prevent injury. Use only the quick disconnect harness supplied with your power chair.
It has a thermal fuse on each lead.
18. Connect the wiring harnesses to the front battery. See figure 35.
WARNING! Prevent injury. Make sure you tighten the fasteners so that the connections are secure.
19. Connect the wiring harnesses to the rear battery. See figure 35.
20. Slide the battery tray back into the power base.
NOTE: Make sure that the power pod is out of the way when reinstalling the batteries.
21. Place the center shroud back on top of the power base and secure the yellow fastener.
22. Reinstall the foot platform.
23. Reinstall the seat.
24. Reconnect the battery connector.
25. Reconnect the controller to the power pad.
26. Reinstall the rear shroud and tighten the fasteners.
27. Charge the batteries. See VI. “Batteries and Charging.”
BATTERY WIRING DIAGRAM
BATTERY CONNECTOR
QUICK DISCONNECT
THERMAL FUSES
Figure 35. Jazzy 1103 Ultra Battery Connections