Panasonic CX-DH801U - Manual (Page 33)

65
CX-DH801U
38
English
64
CX-DH801U
37
English
Electrical Connection
(Continued)
Connection with DVD/monitor receiver (CQ-VD7001U)
Connection with DVD/monitor receiver with CD/DVD changer control (option, CQ-VD7001U)
Note: Refer to the operating instructions for the connected devices, in addition.
Electrical Connection
Caution: For safety, be sure to ask your nearest professional installer to do this connection.
Connecting the Parking Brake (Side Brake) Connection Lead
– +
The parking brake (side brake) switch position varies with the car model.
For details on the exact location of the parking brake (side brake) switch in
your car, contact your dealer.
Parking Brake (Side Brake) Connection Lead
(Blue/yellow stripe)
When the parking brake (side brake) lever is
engaged, the unit is grounded by the chassis.
Parking brake
(Side brake)
switch
Car chassis Battery
Brake light
Clip Connector i
q Attach a Clip Connector i to the end of the parking
brake (side brake) connection lead.
w The Clip Connector i is connected to the power
source side lead of the parking brake (side brake)
lever.
Parking Brake (Side Brake) Connection Lead
(Blue/yellow stripe)
Comes up to this point.
Power source side lead
Parking (side) brake Foot brake
ACC ACC
H A
M4X5mmMAX
B C
V
H.A
H
C V.A.B
V
B
C
BATTERY 5A
PARKING BRAKE
VIDEO-CNT
CH/AUX IN
VTR IN
REMOTE-IN
Ground
Lead
To a clean, bare metallic part of the car chassis
Battery Lead
To the car battery, continuous + 12 V DC.
Video control Lead (output)
(Green/yellow stripe)
Not used.
Extension Cord u
(BRAKE/VIDEO-CONT/ACC/BATT/DIN/RCA/GND)
(Black)
(Red)
(Yellow)
DVD Changer
CX-DH801U
RCA Cable
Video Output (Yellow)
CQ-VD7001U
(option)
RCA Cable (option) Remote-out
(Black)
Be sure to wire the park-
ing brake for safety and
preventing accident.
Fuse 5 A
Not used.
Parking Brake Lead
(Blue/yellow stripe)
DIN Cable
(Black)
To the changer
connector.
DIN Connector
Audio Output (L)
(White)
Audio Output (R)
(Red)
(R) (Red)
(L) (White)
Changer/AUX/XM receiver
Input Connector
(Yellow) Video Input Terminal
Power
Lead Not used. Do not connect the Power Lead
(ACC) if the control unit is equipped.
Note: Never use both Remote-Ins
(one is mini-pin jack, the other is RCA
jack) at the same time. Failure to
observe this may cause misoperation.
Note: Select [VTR] in [CH INPUT] of the [INPUT/OUTPUT] menu in advance if you would like to watch the display of the
DVD changer with CQ-VD7001U ( a page 9).
Remote-In
(RCA) (Black)