Panasonic CX-DH801U - Manual (Page 34)

67
CX-DH801U
40
English
66
CX-DH801U
39
English
Electrical Connection
(Continued)
Connection without Control Unit
Connections for the minimum combination (CY-V7100U, option)
Notes:
• Refer to the operating instructions for the connected devices, in addition.
• Connect the included remote control sensor to Remote-In in the case of no remote control sensor on the display unit.
VIDEO
CNT
CY-V7100U
PHONES
PARKING BRAKE
H A
M4X5mmMAX
B C
V
H.A
H
C V.A.B
V
B
C
REMOTE-IN
REMOTE-OUT
REMOTE-IN
BATTERY 5A
ACC
VIDEO-CNT
DVD Changer
CX-DH801U
Extension Cord u
(BRAKE/VIDEO-CONT/ACC/BATT/DIN/RCA/GND)
Ground Lead
To a clean, bare metallic
part of car chassis
Parking Brake Lead
Be sure to wire the parking
brake for safety and pre-
venting accident.
Power Lead
To ACC power, + 12 V DC.
DIN Cable Not Used
(Black)
(Red)
(Black)
(Yellow)
(Blue/yellow stripe)
Video Control Lead (output)
(Green/yellow stripe)
Video control lead (input)
(Green/yellow stripe)
Remote-In (Not used)
Remote-Out (Not used)
Remote-In
(RCA)
(Black)
(Black)
(Black)
RCA Cable
Audio Output
(R)
(Red)
(L)
(White)
Video Output
(Yellow)
Remote Out Lead
(Black)
RCA Cable
(option)
Fuse 5 A
Battery Lead
To the car battery, contin-
uous + 12 V DC.
Display Unit
CY-V7100U
(option)
Hide-away Unit (rear)
CY-V7100U
(option)
Hide-away Unit
(front)
CY-V7100U (option)
DIN Connector
Electrical Connection
Note: Never use both Remote-Ins (one
is mini-pin jack, the other is RCA jack)
at the same time. Failure to observe this
may cause misoperation.
Headphones
(option)
Caution: The driver should not wear headphones while driving.
Connection with CD/Receiver (CQ-C9901U)
Connection with CD/Receiver with CD/DVD changer control (option, CQ-C9901U/CY-V7100U)
Note: Refer to the operating instructions for the connected devices, in addition.
DVD Changer
CX-DH801U
ACC
BATTERY 5A
PARKING BRAKE
H A
M4X5mmMAX
B C
V
H.A
H
C V.A.B
V
B
C
VIDEO-CNT
CY-V7100U
PHONES
CH/AUX2-IN
REMOTE-IN
VIDEO CNT
Extension Cord u
(BRAKE/VIDEO-C0NT/ACC/BATT/DIN/RCA/GND)
Ground
Lead
To a clean, bare metallic part of the car chassis
Battery Lead
To the car battery, continuous + 12 V DC.
(Black)
(Red)
(Yellow)
Parking Brake Lead
(Blue/yellow stripe)
Display Unit
CY-V7100U
(option)
Be sure to wire the parking brake for
safety and preventing accident.
Video control Lead (output)
(Green/yellow stripe) Video Control Lead (input)
(Green/yellow stripe)
Video Output (Yellow)
Remote Out Lead (Black)
Video-IN
RCA Cable
Audio Output
Audio Output
(R) (Red)
(L) (White)
CD/DVD Changer
/AUX/XM receiver
Input Connector
DIN Cable
(Black)
Changer Control
Connector
CQ-C9901U (option)
Power Connector
Fuse 5 A Remote Control Sensor
Extension Cord (option)
Hide-away Unit
(rear)
CY-V7100U
(option)
Hide-away Unit
(front)
CY-V7100U (option)
VTR-1
VTR-2
DIN Connector
Not used.
Power
Lead
Not used. Do not connect the Power Lead
(ACC) if the control unit is equipped.
Note: Never use both Remote-Ins (one is mini-pin
jack, the other is RCA jack) at the same time.
Failure to observe this may cause misoperation.
Remote-In
(RCA) (Black)