Patton electronic 1088/K - Manual (Page 7)

7
3.0 INSTALLATION
The Model 1088/K is equipped with two sets of eight DIP switches, which
allow configuration of the unit for a wide variety of applications. This section
describes switch locations and explains all possible configurations.
3.1 CONFIGURING THE HARDWARE DIP SWITCHES
The 16 external switches are grouped into two eight-switch sets, and are
externally accessible from the underside of the Model 1088/K (See
Figure 1).
Figure 1. Underside of Model 1088/K showing location of DIP switches
The two sets of DIP switches on the underside of the Model 1088/K will
be referred to as S1 and S2. As Figure 2 shows, the orientation of all DIP
switches is the same with respect to “ON” and “OFF” positions.
Figure 2. Close-up of configuration switches (all sets are identical in appearance)
OFF
ON