Panasonic 44-Series - Manual (Page 30)

2. Setting Up Your Phone
28 Issued April 2000 DBS-32-755
For example:
Note: The PSD bin for each one-touch or soft key appears on the display
when the phone is in Personal Speed Dial mode. On large-display phones,
either 5 or 10 bins are displayed at a time, depending on how your extension is
programmed. You can display the next group of bins by pressing the “NEXT”
key, or the previous group by pressing the “PREV” key.
On small-display phones, two bins are displayed at a time. Press the “#” key
to display the next two bins and the “*” key to display the previous two bins.
Assigning PSD Numbers to One-Touch or Soft Keys
1. Pick up the handset or press ON/OFF.
Note: On a large-display phone, you will need to be in Personal Speed
Dial mode before you can assign PSD numbers. If you are not sure you are
in this mode, press the MENU key to display the Main Menu, then press
the key to the left of PERSONAL DIAL on the Main Menu.
2. Press PROG.
3. Press the desired one-touch or soft key (or press AUTO, then enter the
desired PSD bin number). The PSD bin for that key appears on the display
(e.g., “Enter PSD 901”). You may want to write down the bin number for
the key - you will need this information to assign a name to the key.
4. Enter the phone number you want to be speed-dialed from that key
(maximum length = 16 characters).
One-touch or soft
key . . .
Corresponds to
personal speed dial bin . . .
10 PSD systems 40 PSD systems*
#1 90 or 900 900, 910, 920, and 930
#2 91 or 901 901, 911, 921, and 931
#3 92 or 902 902, 912, 922, and 932
etc.
*A maximum of ten PSD numbers can be assigned to the one-touch keys on a
small-display or non-display phone.