Panasonic 44-Series - Manual (Page 32)

2. Setting Up Your Phone
30 Issued April 2000 DBS-32-755
Clearing a PSD Number From a One-Touch or Soft Key
1. Pick up the handset or press ON/OFF.
2. Press PROG.
3. Press the desired one-touch or soft key.
4. Press HOLD.
5. Replace the handset or press ON/OFF.
Assigning Names to PSD Numbers
After assigning a PSD Number to a one-touch or soft key, you can assign a
name such as “Home”, etc., to the key. PSD names are displayed when you
are in the Personal Speed Dial mode.
Note: You will need to know the PSD bin number for the key in order to
assign a name to it. To check the bin number for a key, see “Checking PSD
Numbers”, above.
1. Pick up the handset or press ON/OFF.
2. Press PROG.
3. Dial #1.
4. Press AUTO.
5. Enter the PSD bin number for the key you want to assign a name to
(Example: 91, 903, etc.).
6. Press AUTO as many times as necessary to clear out the default name.
(The AUTO key can also be used to backspace if an error is made while
programming PSD and SSD names.)
7. Enter the first character of the name you want to assign to the key. Use the
information in Table 4 as a guide.
Note: To enter numbers into a name, press CONF. To resume entering
letters, press CONF again.
8. Press FLASH to move to the next character in the name.
9. Repeat steps 7-8 for each character in the name until the entire name is
entered. (If you make a mistake, you can backspace by pressing AUTO.)