Powerware BestLink IPK-0319 - Manual (Page 17)

Local Configuration
11 BestLink SNMP/WEB Adapter User’s Guide
:
LTM-1343 B Draft 10/03/2001
5. Type 0 to exit the BestLink Adapter configuration. The BestLink
Adapter automatically reboots and saves all settings after exiting the
configuration function (see Figure 8).
NOTE The BestLink Adapter may take up to two minutes to reboot. Please wait before
attempting communication with the adapter from a web browser or NMS.
NOTE Telnet Operation – Once the adapter is reachable on the network, you can use a
telnet utility to adjust any of the configuration settings. The menus are identical to those
seen during serial configuration and are password-protected for Superuser access only.
NOTE For an Internal BestLink Adapter – In a FERRUPS 0800, Axxium Pro, or Powerware
9170 UPS, you MUST change the Config BestDock parameter for that UPS back to NO or UPS
as applicable. Refer to the UPS user’s guide for detailed instructions on changing the
parameter through the UPS front panel configuration menu.
+============================================================================+
| [ BestLink SNMP/WEB Adapter Configuration Utility ] |
+============================================================================+
1. Set the IP Address, Gateway Address and MIB System Group
2. Set SNMP/WEB Card Control Group
3. Set Write Access Managers
4. Set Trap Receivers
5. Set IP Addresses of Primary and Secondary Date Server
6. UPS Event Actions
7. Set UPS information
8. Set Superuser Name and Password
9. Email Notification
0. Back to Main Menu
Please Enter Your Choice =>0
+============================================================================+
| [ BestLink SNMP/WEB Adapter Configuration Utility ] |
+============================================================================+
1. SNMP/WEB Card Settings
2. Reset Configuration to default
3. Restart SNMP/WEB Card
0. Exit
Please Enter Your Choice =>0
Figure 8. Exiting the Configuration Program