Powerware BestLink IPK-0319 - Manual (Page 19)

Local Configuration
13 BestLink SNMP/WEB Adapter User’s Guide
:
LTM-1343 B Draft 10/03/2001
Set Trap Receivers
For those users who intend to use an SNMP-compatible NMS to manage the
BestLink Adapter, the IP address of the machine intended to be the trap
receiver must be added in the list on the BestLink Adapter. Use this function
to add or delete the IP address of the trap receivers (option
4 ).
Set IP Addresses of Primary and Secondary Date Server
Use this function to set the IP addresses of the primary and secondary date
servers (option
5 ). Making changes to these parameters is allowed via the
HTML interface for easy updating. To reset the adapter to the default values
(0.0.0.0), you must program the BestLink SNMP/WEB Adapter via the serial
configuration to “Reset Configuration to Default.”
NOTE Resetting the adapter changes the entire BestLink Adapter configuration to the
default values.
Computer systems with the BestLink Adapter-compatible NetWatch client
software are periodically monitored by the BestLink Adapter to maintain a
consistent date and time with your network. Failing to program the primary
and secondary date server parameters to some value other than 0.0.0.0, causes
the BestLink Adapter to check all NetWatch clients (if present on the
network) for the best average time.
UPS Event Actions
Use this function to configure actions that the BestLink SNMP/WEB Adapter
performs during AC Fail and Low Battery events (option
6 ). This information
is accessible via the HTTP interface for easy modification after the adapter is
on the network.
Set UPS Information
Use this function to enter additional information about the UPS including
date of installation and date of last battery replacement (option
7 ). In
addition, set timing values relating to the shutdown and restart of the UPS via
this function. This information is accessible via the HTTP interface for easy
modification after the adapter is on the network.