Screenlogic video & lighting protocol adapter name – Pentair ScreenLogic BL-C111A User Manual

Page 5

Advertising
background image

ScreenLogic Video & Lighting Protocol Adapter User’s and Installation Guide

3

Connecting the ScreenLogic Video & Lighting Protocol
Adapter

The following describes how to connect the Video & Lighting Protocol adapter
to an existing ScreenLogic system.

1.

Connect the provided RJ45 (CAT5) cable to an available port (1, 2, 3,
or 4) on the ScreenLogic wireless router. Connect the other end of the
cable to the LAN port on the Video & Lighting Protocol adapter (see
diagram on page 2).

2.

Lights cable connection: Connect an RJ45 (CAT5) cable to the
COM 1 port on the adapter. Connect the other end of the cable to the
DB9M/RJ45 adapter. Connect the DB9M/RJ45 adapter to the RS-232
connector that is connected to the UPB Powerline Interface Module
(PIM). See diagram on page 2.

3.

Camera cable connection: Connect AC power plug to the video
camera(s). Connect the RJ45 camera cable to port 1, 2, 3, or 4 on the
ScreenLogic wireless router (see diagram on page 2).

If additional cameras are being installed, a Network Switch can be
used to provide available ports. ScreenLogic supports a maximum of
four cameras (see diagram on page 2).

ScreenLogic Video & Lighting Protocol Adapter Name

The Video & Lighting Protocol adapter system name is identified on the
screen as:
Pentair: xx-xx-xx (where xx-xx-xx are the last six (6) digits of the unit’s serial
number which can be found on a sticker on the adapter). The name is
displayed on the ScreenLogic Connect dialog as shown below:

ScreenLogic Video & Lighting

Protocol Adapter name

Pentair Brick

(192.168.2.2.:80) is the

existing ScreenLogic

Protocol Adapter IP address.

Do not configure this

adapter.

Check this box to save the

current login information

Advertising