Pentair ScreenLogic BL-C111A - Manual (Page 9)

ScreenLogic Video & Lighting Protocol Adapter User’s and Installation Guide
5. Select the camera manufacture and model and click the OK button.
6. Select the installed video camera model to rename the camera and set
its IP address. The cameras IP address must be in the same subnet
range as your ScreenLogic Video & Lighting Protocol Adapter. The
default IP address for the ScreenLogic Video & Lighting Protocol
Adapter is 192.168.2.3 - It is recommended that you select a higher IP
address to avoid conflict on your network. For example, use
192.168.2.80 for camera No. 1, 192.168.2.81 for camera No. 2, etc.
7. For additional cameras, click the Add New Camera button and repeat
steps 1 - 6.
8. Click Done when finished. The Configuration setup dialog box will be
displayed.
7
Note: Only configure
one camera at a time.
For example, connect
the first camera, then
configure it. Plug in the
second camera and
repeat.