Philips SCD488 - Manual (Page 11)

EN
Other features
11
2 Briefly press the Volume + and – buttons (B-9) on the parent
unit repeatedly until the desired microphone sensitivity for
the baby unit has been reached.
Note: If you press the SENSITIVITY button (B-2) and/or the
Volume + and – buttons (B-9) too long, the microphone
sensitivity will not be adjusted.
> The sound-level lights (B-8) give visual feedback on the new
setting for approximately 2 seconds:
- 1 light (1 x orange) = minimum level / lowest sensitivity;
- all lights (5 x orange) = maximum level (continuous
transmission) / highest sensitivity.
Note:When the sensitivity level of the baby unit is set to a high
level, the unit will consume more power because it is in
continuous transmission mode.
Monitoring baby silently
• Briefly press the Volume – button (B-9) on the parent unit
repeatedly until the volume is switched off completely.
> All sound-level lights (B-8) will now be off.
> When no sound is detected all sound-level lights (B-8) will
be off.
> When a sound is detected the sound-level lights (B-8) light
up orange.
Switching night light on/off
1 Briefly press the night light button ( ) (A-7) on the baby unit
to switch on the night light (A-3).
2 Briefly press the night light button ( ) (A-7) again to switch
off the night light (A-3).
> The night light dims and gradually switches off.
• Switch off the night light when operating the baby unit with
batteries.This saves power!