Getting your baby monitor ready for use, Parent unit – Philips SCD488 User Manual
Page 7
EN
Battery operated use
1 Open the battery compartment by turning the cover (A-9) to
the left (
1 OPEN), using the palm of your hand.Take off the
cover.
2 Insert four 1.5V AA batteries, noting the + and –
configuration inside the battery compartment (batteries are
not supplied; we recommend Philips Alkaline batteries).
3 Put the battery compartment cover (A-9) back in place.
Close the compartment by turning the cover (A-9) to the
right (CLOSE
2), using the palm of your hand.
➜ The baby unit is now ready for battery operated use!
Parent unit
1 Open the battery compartment by sliding the cover (B-11)
downwards.
2 Insert the two 1.2V AAA size Ni-MH rechargeable batteries
(supplied), noting the + and – configuration inside the battery
compartment.
3 Put the battery compartment cover (B-11) back in place.
Close the compartment by sliding the cover (B-11) upward
until it clicks in position.
Getting your baby monitor ready for use
7