Panasonic TZ-DRD100 - Manual (Page 19)

18
G ETTING S TARTED
Step 1c. Digital Satellite Receiver connection to TV or Monitor
Follow this diagram when connecting the Digital Satellite Receiver to a Television or
Monitor.
Procedure
• Connect the VHF (SAT) /UHF OUT to the ANT IN of the television or connect video cable
from the video output jack on the Digital Satellite Receiver to the video input jack on the TV.
• Connect audio cables from the left and right NTSC audio output jacks on the Digital
Satellite Receiver to the left and right audio input jacks on the TV.
To receive off-air programming (no cable box)
• Turn off the Digital Satellite Receiver or press TV/SAT button to toggle.
• Tune TV to desired channel.
To receive off-air programming (with cable box)
• Turn off the Digital Satellite Receiver or press TV/SAT button to toggle.
• Tune TV to cable box output channel (either CH3 or Ch4).
• Tune the cable channels using the cable box.
Note: Modem should also be connected to a telephone jack using the cable supplied RJ11C
cable if impulse pay per view services are desired.
DIGITAL SATELLITE RECEIVER CONNECTION TO TV OR MONITOR
SATELLITE
IN
R-AUDIO-L VIDEO
NTSC OUTPUT
TEL LINE AC IN
Incoming signal from
cable or antenna
TV
ANT IN
INPUT
AUDIO
R L VIDEO
Digital Satellite Receiver
VHF (SAT) /UHF
OUT
VHF/UHF
IN
NOTE: A/V CABLES AND MODEM
CABLE INCLUDED.