Programming the remote control – Panasonic TZ-DRD100 User Manual

Page 27

Advertising
background image

26

P

ROGRAMMING

THE

R

EMOTE

C

ONTROL

Programming the Remote Control

The Universal Remote Control can be programmed to operate many manufacturers’
components using the component function buttons for TV, VCR, DVD. Follow the
procedures for programming your Remote Control with and without codes for the
component. Determine the manufacturer of the component and look in the table for
the code.

Programming With Code

Confirm that the external component is plugged in and is turned on.

Turn the component off.

Press the ACTION and POWER button, together, for at least 5 seconds and
then let go of the buttons.

Press appropriate component button (TV, VCR, DVD) on the Remote Control.

Enter the 3-digit component code using the Remote Control numeric keypad
(0 ~ 9 buttons). If a proper code was entered, the mode button will blink twice
and go out.

Press the Remote Control POWER button to test the component. If the
procedure was successful, the component will turn on.

Programming Without Code

This procedure searches all codes and is called the “sequence method”.

Confirm that the external component is plugged in and is turned on.

Turn the component off.

Press the ACTION and POWER button, together, for at least 5 seconds, and
then let go of the buttons.

Press appropriate component button on the Remote Control.

Press the

button to move forward to the next code. Press the

button to

move backward.

Press the Remote Control POWER button to test the component. If the
procedure was successful, the component will turn on.

Note:

Repeat the preceding two steps until the component code is found. It may take many attempts
before the correct code is found.

After the code is found, press the ACTION button to store the code.

Unsuccessful Code

If the component does not operate with the Remote Control,
repeat the procedure using another code. (Some brands have
multiple codes.)
If an incorrect code is entered, or if the procedure takes longer
than 30 seconds, the programming will fail.

Advertising