Panasonic TZ-DRD100 - Manual (Page 21)

20
G ETTING S TARTED
Step 1e. Digital Satellite Receiver Connection to VCR
Follow this diagram when connecting the Digital Satellite Receiver to a standard VCR.
Procedure
• Connect video cable from the video output jack on the Digital Satellite Receiver to the video
input jack on the VCR.
• Connect audio cables from the left and right audio output jacks on the Digital Satellite
Receiver to the left and right audio input jacks on the VCR.
• Connect video cable from video output jack on the VCR to video input jack on TV.
• Connect the audio out cables from the audio output jacks on the VCR to the audio input
jacks on the TV.
To record off-air programming
• Turn off satellite receiver or press TV/SAT button to toggle. Tune the VCR to desired
channel and push record button on the VCR to start recording
Note: This Digital Satellite Receiver incorporates an anticopy process technology that
is protected by U.S. patents and other intellectual property rights measures. The
anticopy process is licensed for non-commercial, home use only. Reverse
engineering or disassembly is prohibited.
SATELLITE
IN
TEL LINE
R-AUDIO-L VIDEO
NTSC OUTPUT
AC IN
VHF/UHF
IN
VHF (SAT) /UHF
OUT
R-AUDIO-L VIDEO
ANT IN
R-AUDIO-L VIDEO
VIDEO IN
VIDEO OUT
ANT OUT
ANT IN
TV
VCR
DIGITAL SATELLITE RECEIVER
Incoming Signal from antenna or cable
VCR SETUP
NOTE: A/V CABLES AND MODEM
CABLE INCLUDED.