Indicator display (front panel led) – Panasonic AJ-HDP2000P User Manual

Page 13

Advertising
background image

13

Indicator Display (Front Panel LED)

The operating state of this unit can be checked on the three LEDs (Alarm Lamp, Horizontal Sample
Display Lamps) on the front panel: Lighting or Blinking.

Display

Description

Normal operating state
(Lighting: When there is no warning or when the warnings are masked from
MENU)

Format error
(In the following cases, 1920 LED or 2048 LED blinks normally or rapidly.)

<Warnings indicated by rapid blinking>

RECORDED FORMAT UNMATCH (NO J2K TAPE):

TAPE is not 2K processor recording format.

<Warnings indicated by normal blinking>

RECORDED FORMAT UNMATCH:

There is a mismatch between SYSTEM FORMAT of the unit selected in
settings and FORMAT of TAPE. (2048/1920, XYZ/RGB)

UNMATCH H SAMPLE BETWEEN INPUT SIGNAL AND SYSTEM:

There is a mismatch in H SAMPLE between the SYSTEM set value and the
input signal.

Other errors
(ALARM Lighting or Blinking: In the case of a warning corresponding to an alarm
indication)

<Warning corresponding to lighting alarm>

2K FAN STOP:

The fan of the 2K processor stops.

2K NO REMOTE: The service switch on the back of the 2K processor is not in

the OFF position.

<Warnings corresponding to blinking alarm>

CRC ERROR IN SERIAL DATA INPUT FROM HDD5:

A CRC error occurs in SERIAL DATA (HD SDI) signals from the HD-D5
VTR main unit to the 2K processor.

OUT OF RANGE OF SYSTEM PHASE BETWEEN REF AND INPUT:

There is a large phase difference between the input signal and REF IN.

INPUT SIGNAL UNMATCH SYSTEM FREQUENCY:

There is a mismatch in frame frequency between the SYSTEM set value
and the input signal.

SUBSTANDARD TIMING DIFFERENCE IN DUAL LINK 2K INPUT:

The timing-phase difference of Dual-Link IN A/Bch is big.

CRC ERROR IN DUAL LINK CHA 2K INPUT:

A CRC error occurs in signals on Dual-Link IN Ach.

CRC ERROR IN DUAL LINK CHB 2K INPUT:

A CRC error occurs in signals on Dual-Link IN Bch.

NO EXTERNAL HD_REFERENCE:

HD REF IN on the HD-D5 VTR is not connected.
(Although this is the existing warning for the HD-D5 VTR, the ALARM LED
of the 2K Processor also blinks.)

or

or

or

(Lighiting or Blinking)

Advertising