Panasonic KV-S6050W - Manual (Page 30)

30
Display Panel Instructions
“Others”setting menu (by pressing the OTHERS key)
Number, mode and default display
• Pressing the 3 key will change to the
next mode.
• Pressing the 4 key will change to the
previous mode.
Contents
• Pressing the 1 key or the 2 key will change to another value.
01 Checking the Version MX.XX : Displays the mechanical control firmware version.
FX.XX : Displays the imprinter firmware version.
If an imprinter unit is not installed, the firmware version
will not be displayed.
02 Setting the “Buzzer”
03 Setting the SCSI ID
• Setting the SCSI ID will be activated after turning the power off
and turning it on again.
04 Setting the “Terminator”
When the scanner is located to terminal position on SCSI bus,
set to “Enable”.
• Setting the terminator will be activated after turning the power
off and turning it on again.
• The internal terminator works only when the units power has
been turned on. If the PC is to be used while the unit’s power is
off, be absolutely sure to install an external terminator which is
available on the market.
05 Setting the transfer rate
• Changes the maximum value of the synchronous transfer rate
of the SCSI interface.
• Lower the synchronous transfer rate to 10 Mbytes/sec. if the
computer has failed to recognize the scanner or the scanner
fails to operate properly.
0 1 . V e r s i
M X . X X F X . X X
o n
0 2 . B u z z e
O N
r
OFF ON
0 3 . S C S I
N o . 6
I D
2 1 3 5 4 6 7 0
0 4 . T e r m i
E n a b l e
n a t o r
Disable Enable
0 5 . T r a n s f e r R a t e
2 0 M B y t e / s e c
20MByte/sec 10MByte/sec