Panasonic KV-S6050W - Manual (Page 50)

50
Cleaning the Unit
6
Close the front door.
• Push both sides of the front door down
gently until it clicks into place.
• Do not close the front door holding the
hopper extension tray.
7
Close the ADF door.
• Push both sides of the ADF door down
gently until it clicks into place.
• Since the roller are located on the left
side of the ADF door, there is more
weight on the left side.
Therefore, it is important to note that the
door needs to have tension evenly
divided to close it properly.
• After cleaning, clear the “Clean Roller
Warning” display. (See page 31 .)
¥
Re-attachment of the sensor roller
When the sensor roller is removed while cleaning the inside of the scanner, re-attach it as shown below.
Lower sensor roller:
Attach the roller by placing the no-gear side
to the left side of the scanner and inserting
both side’s bearings into the guide grooves.
•
Match the flat side of the bearing with the flat
side of the guide groove.
• After attaching, press down on top of the sensor
roller with your finger to confirm if it moves or
not.
Hopper
extension tray
Sensor roller
Flat side of the bearing
Please attach the right side bearing in the same way.
Bearing
Guide groove