Panasonic KX-FC228HK - Manual (Page 46)

8. Programmable Features
46
8.1.2 Advanced features
Changing the maximum
recording time for
incoming messages
*1
{#}{ 1}{0} { 1} “ 1 MINUTE”
{ 2} “ GREETING ONLY”: The unit plays the greeting message but
does not record any incoming messages.
{
3} “ 3 MINUTES” (default)
Note:
L You can also program this feature with the cordless handset
(page 43).
Setting the remote
operation ID
*1
{#}{ 1}{1} 1. {MENU} i {#}{1}{1}
2. To activate the remote operation feature, enter a 3-digit
remote operation ID.
L To deactivate the remote operation feature, press {*}.
3. {SET} i {MENU}
Note:
L You can also program this feature with the cordless handset
(page 43).
Setting the dialling
mode (for the base unit
and cordless handset) {#}{ 1}{3} If you cannot make calls, change this setting according to your
telephone line service.
{
1} “ PULSE”: For rotary pulse dial service.
{ 2} “ TONE” (default): For tone dial service.
Setting the ringtone for
outside calls
*2
{#}{ 1}{7} { 1} “ RINGTONE 1” (default)
{ 2} “ RINGTONE 2”
{ 3} “ RINGTONE 3”
{ 4} “ RINGTONE 4”
{ 5} “ RINGTONE 5”
{ 6} “ RINGTONE 6”
*1 When this setting is changed using the base unit, the setting for the cordless handset will also be changed, and
vice versa.
*2 This setting can be changed individually for the base unit and the cordless handset.
– To set the cordless handset ringtone for outside calls, see page 52.
Feature Feature code Selection
Setting the journal
report to print
automatically {#}{ 2}{2} { 0} “ OFF”: The unit will not print a journal report, but will keep a
record of the last 30 fax transmissions and receptions.
{
1} “ ON” (default): The unit will print a journal report automatically
after every 30 new fax transmissions and receptions (page 29).
Sending documents
overseas {#}{ 2}{3} If you cannot send a fax overseas even if the number is correct
and the line is connected, activate this feature before sending the
fax.
This feature improves the reliability by reducing the transmission
speed.
{
0} “ OFF”: Deactivates this feature.
{ 1} “ NEXT FAX”: This setting is effective only for the next
attempted fax transmission. After transmission, the unit will return
to the previous setting.
{
2} “ ERROR” (default): When the previous fax transmission fails
and you wish to re-send the document.
Note:
L Calling charges may be higher than usual.
Feature Feature code Selection
FC228HK-PFQX2656ZA-en.book Page 46 Thursday, August 31, 2006 11:35 AM