Panasonic KX-FC228HK User Manual
Page 64
11. Help
64
11.3.3 Cordless handset
During programming, I
cannot enter the code or ID
number.
L
All or part of the number is the same as another code or ID. Change the
number:
–
remote operation ID (code): page 43, or feature #11 on page 46.
–
fax activation code: feature #41 on page 48.
–
auto disconnection code: feature #49 on page 49.
The ink film runs out quickly.
L
Even if there are only a few sentences, every page that comes out of the
machine is considered a full page.
L
Turn OFF the following features:
–
sending report: feature #04 on page 45.
–
journal report: feature #22 on page 46.
–
Caller ID list: feature #26 on page 47.
The base unit beeps.
L
The memory reception alert of feature #44 is ON (page 48), and the unit has
a document in memory. Press {STOP} to stop the beeps, then see the
displayed message instructions to solve the problem.
The speakerphone is not
working.
L
Use the speakerphone in a quiet room.
L
If you have difficulty hearing the other party, adjust the volume.
I cannot page a cordless
handset or base unit.
L
The cordless handset is too far from the base unit.
The unit does not display the
caller’s name and/or
telephone number.
L
You need to subscribe to a Caller ID service.
L
Other telephone equipment may be interfering with your phone. Disconnect
it and try again.
L
Other electrical appliances connected to the same outlet may be interfering
with the Caller ID information.
L
Telephone line noise may be affecting the Caller ID information.
L
The caller requested not to send his/her information (page 23).
L
Depending on the service of the local telephone company, caller information
may not be displayed on the cordless handset in TEL/FAX mode. In this
case, change the TEL/FAX ring setting to 1 (feature #78 on page 50).
L
If a call is being transferred to you, the caller information will not be
displayed.
The display exits the Caller ID
List while viewing caller
information.
L
Do not pause for over 1 minute on the cordless handset or 3 minutes on the
base unit while viewing.
Problem
Cause & Solution
The cordless handset does
not work.
L
Make sure that the battery is installed correctly (page 13) and fully charge
it (page 15).
L
Clean the charge contacts and charge again (page 15).
L
Turn the cordless handset power OFF, then ON (page 15).
L
Check that the power cord is connected properly.
L
The cordless handset has not been registered to the base unit. Register the
cordless handset (page 55).
The cordless handset display
is blank.
L
The cordless handset is not turned ON. Turn the power ON (page 15).
The cordless handset will not
turn ON.
L
Make sure that the batteries are installed correctly (page 13).
L
Fully charge the batteries (page 15).
L
Clean the charge contacts and charge again (page 15).
Problem
Cause & Solution
FC228HK-PFQX2656ZA-en.book Page 64 Thursday, August 31, 2006 11:35 AM