Philips FMod-TCP BOX - Manual (Page 19)

19 / 58
Easy IP address config (UDP # 7010)
A really useful feature of the UDP port #7010 is the "Easy IP config" one.
The user who wants to design his own software can use this feature to do a
"quick start/install" method. Indeed, since this protocol uses a broadcast UDP
packet, even if the device is not in the same subnet, it should receive its new
IP address and subnet mask.
Procedure:
Send a UDP broadcast message (using a local or direct broadcast IP address)
to your network (inside which the FMod-TCP BOX is connected) with the
following command:
Byte# Number of bits Example
0x00 Change IP fct (0x002A) 16 bits 0x002A
0x02 TransactionID 16 bits 0x0000
0x04 Length of params (0x000E) 16 bits 0x000E
0x06 FMod-TCP BOX Mac Address 6 bytes 0x0050C2308101
0x0C FMod-TCP BOX new IP
Address
4 bytes 0xC0A81064
0x10 FMod-TCP BOX new
SubnetMask 4 bytes 0xFFFF0000
0x14 Checksum 16 bits 0x…
If the FMod-TCP BOX recognizes its MAC address, it will answer this
command with a simple acknowledges and change its IP address and subnet
mask IF NO TCP CONNECTION IS MADE TO THE DEVICE.
Byte# Number of bits Example
0x00 Change IP fct ack (0x002B) 16 bits 0x002B
0x02 TransactionID 16 bits 0x0000
0x04 Length of params (0x0000) 16 bits 0x0000
0x14 Checksum 16 bits 0x…
FMod-TCP User Manual v.2.8