Panasonic SC-HC40 - Manual (Page 6)

RQTX1146 RQTX1146
6
ENGLISH
RQTX1146 RQTX1146
3. Drive the mounting screws into the wall.
AUX
1. Detach the stand from the unit.
2. Attach the wall bracket to the back of the unit.
 Secure the wall bracket with fixing screw (2 pieces).
[Tightening torque: 1.2 Nm (57/64 lb-ft) to 1.5 Nm (1 7 /
64
lb-ft)]
 Align both tabs on the wall bracket and the main unit, then slide it
in until it clicks into place.
Wall mount instructions
• Before installation, turn the unit off and disconnect the AC power supply cord plug from the AC receptacle.
• Tighten screws firmly to prevent slack in each step.
A
Bottom of main unit
Stand
Soft blanket
or cloth
Fixing screw A
B
Fixing screw B
Tab
Rear of
main unit
300 mm (11 13 /
16
")
Space required
Rear View
Space required
85.5 mm (3 3 /
8
") 77.5 mm (3 1 /
16
")
500 mm (19 11 /
16
")
700 mm (27 9 /
16
")
74.8 mm
(2 15 /
16
")
130 mm
(5 1 /
8
")
8 mm (5/16") to 9.5 mm (3/8")
2.2 mm (3/32") to 2.8 mm (7/64")
2.5 mm (3/32") to 3.5 mm (9/64")
4 mm
(5/32")
A length which supports the strength of
20 k
g (44 lb.) or more must be kept for
each screw.
Wall
Mounting screw C
163 mm (6 7 /
16
")
C
Attaching the unit to a wall (Optional)
(continued)
6 7
 Measure and mark the position of the mounting screw (2 pieces) and drive them into the wall.
Use figures below for screw positions and measurements.
Please install using both wall mounting screws.
Use a level ruler to ensure both screws are level.
Use a screw which is strong enough to support the weight of at least 20 k
g (44 lb.).
•
•
•
•
 Slide the stand off the unit.  Unscrew the fixing screw (2 pieces) at the bottom of the unit.
Keep the removed screws in a safe place.
Wall bracket (bottom view)
2
1