Panasonic SC-HC40 - Manual (Page 9)

RQTX1146 RQTX1146 RQTX1146 RQTX1146
9
ENGLISH
9
Disc operations
g Inserting a disc
 Press [^] to turn the unit on.
 Press [;, CD] to open the sliding door.
Program play
 Press [^] to turn the unit on.
 Insert the disc to be played (➡ left).
 Press [CD q/h] to start play.
Stop Press [g, ].
Pause Press [CD q/h]. Press again to resume play.
Skip track Press [u] or [i].
Search the current
track
(CD)
Press and hold [u] or [i].
Skip album (MP3) Press [e,r].
Direct access play
(Play starts with the
track you select.) CD: Press the numeric buttons to select the
track.
MP3:  Press [e,r] to select the album.
 Press [i] once and then the numeric
buttons to select the track.
g Removing a disc
 Press [;, CD] to open the sliding door.
 Hold the center and the top right of the disc and pull the top right
of the disc to unlock it from the spindle.
 Tilt the disc so as not to touch the sliding door and remove the
disc.
Damage may occur if the sliding door is forced closed.
Be careful of CD hitting the sliding door while being removed.
•
•
Basic play
 With the label of the disc facing towards you, tilt the disc into the
disc tray under the sliding door.
 Place the disc onto the spindle in the center and then push the
disc down until it clicks into place.
 Press [;, CD] to close the sliding door.
Keep fingers away from the sliding door when it is closing to avoid
possible minor injuries.
Click! !
Enables you to program up to 24 tracks.

Press [CD q/h] and then [g, ].
 Press [PROGRAM].
CD:  Press the numeric buttons to select the track.
To program more tracks, continue by pressing the numeric
buttons.
 Press [OK] or [CD q/h] to start play.
MP3:  Press [e,r] to select the album.
 Press [i] once and then the numeric buttons to select the
track.
 Press [OK].
To program more tracks, repeat step  to .
 Press [CD q/h] to start play.
Cancel program
mode Press [PROGRAM] in the stop mode to clear
“PGM” indicator from the display.
Replay the program Press [PROGRAM] in the stop mode and then
[CD q/h].
Check program
contents Press [u] or [i] when “PGM” is displayed
in the stop mode. To check while programming,
press
[PROGRAM] twice after “PGM” appears
and then press [u] or [i].
Delete last
programmed track Press [DEL] in the stop mode.
Clear all
programmed tracks Press [g, ] in the stop mode.
“CLR ALL” is displayed. Within 5 seconds,
press the button again to clear all tracks.
The program memory is cleared when you open the sliding door. •
Press [DISPLAY, –DIMMER] repeatedly during play or pause to view
the current track’s information.
Maximum number of displayable characters: approximately 30
This unit supports ver. 1.0 and 1.1 ID3 tags. Text data that is not
supported will not be displayed. •
•
Display function