Panasonic RAMSA WR-DA7 - Manual (Page 49)

3 - 7
8. New feature allows Soloing of the Surround Channels
Previous Versions: When monitoring with the Surround Sound enabled, you
could not Solo the Surround enabled Channels. (Solo was always (in stereo)
from the Monitor A signal path.)
Version 2.0: When the [SOLO POSITION] is set to [IN PLACE] from within
the Solo/Monitor Window, then SOLOing of the Surround Channels will
appear in the Surround Monitor. To adjust the monitor level, make the
adjustments to the [MASTER LEVEL] in the [SURROUND MONITOR], instead
of [SOLO LEVEL].
Caution: while you are recording Surround signals to Tape, do not use this
feature as it can cause a feedback loop.
9. New feature allows monitoring of Tape Returns in Surround Monitor
(Playback Only)
Previous Versions: The Surround Sound output signals could be monitored
through the Tape Sends only.
Version 2.0: The Surround signals can be monitored through the Tape
returns in SLOT #1-#3. To monitor the signals of SLOT 1, press #1 in the
Ten-key while holding down the MMC button. Similarly, to monitor SLOT 2
press #2 in the Ten-key while holding down the MMC button, to monitor
SLOT 3, press #3 in the Ten Key Pad while holding down the MMC button.
To return to normal operation, press the same buttons on the Ten Key Pad
again.
Caution: while you are recording Surround signals to Tape, do not use this
feature as it can cause a feedback loop.