Backup battery mode, Set the sleep timer, Adjust display brightness – Philips SJ/T113632006 User Manual

Page 14: Adjust display brightness 1, Install backup batteries

Advertising
background image

14

Note

Batteries contain chemical substances, so they

•

should be disposed of properly.

Set the sleep timer

Note

Make sure the time/date is set correctly before

•

setting the sleep timer.

This unit can switch to standby automatically

after a set period of time.

1

Press SLEEP repeatedly to select a set

period of time (in minutes).

The sleep timer is activated

»

The display shows

»

The volume starts to decrease

»

gradually from the last 5 minutes of

sleep timer
The unit switches to standby when

»

reaches the set time.

To deactivate sleep timer

1

Press SLEEP repeatedly until [OFF]

displays.

»

disappears on the display.

Adjust display brightness
1

Press BRIGHTNESS/REP ALM

repeatedly to select different levels of

display brightness.

Backup Battery Mode

Under normal use, the unit should be powered

through the AC adapter. If the AC adapter is

disconnected, the unit will automatically switch

to Backup Battery mode.

Under Backup Battery mode:

The unit displays the same as under the

•

Standby mode, with backlight off.

Only the functions below are available:

•

Clock

•

Alarm

•

Note

Alarm source is defaulted to ‘Buzzer’ under

•

Backup Battery mode.

When AC Power is plugged back, the unit will

exit Backup Battery mode and go to Standby

mode.

Note

Under Backup Battery mode, the unit can

•

work over 3 months.

When the battery power is low, the display

•

panel will indicate “bAtt Lo” until the batteries

are empty and the unit will switch off

automatically. In this case, please replace the

batteries in the backup battery compartment

with 2 pieces of new 1.5V, AAA/R03/UM4

batteries.

Install backup batteries

Caution

Risk of explosion! Keep batteries away from

•

heat, sunshine or fire. Never discard batteries

in fire.

Risk of product damage! When the apparatus

•

is not used for long periods, remove the

battery.

1

Open the battery compartment on the

back of the unit.

2

Insert 2 x 1.5V R03/UM-4/AAA batteries

with correct polarity.

3

Close the battery compartment.

EN

DC220_93_UM_V1.0.indb 14

2010-4-9 9:43:26

Advertising