Philips AJ3916CD - Manual (Page 5)

Congratulations on your purchase and wel-
come to Philips!
To fully benefit from the support that Philips
offers, register your product at
www.philips.com/welcome.
Controls (see
1)
1 REPEAT ALARM/BRIGHTNESS CON-
TROL – pushes to switch off alarm for a 9-
minute period/changes the brightness of the
display illumination.
2 MODE
– selects different play modes: e.g. REPEAT or
SHUFFLE (random order)
– sets clock time
3 ); – starts/ pauses CD playback
4 STANDBY-ON
– switches the set on or to standby
5 PRESET +/–
– selects a preset radion station.
6 VOLUME – adjusts sound level
7 SOURCE
– selects CD, relaxation music, radio or AUX
source of sound
8 ∞ / §
– adjusts clock / alarm time
– skips CD tracks/ searches for a particular
passage
9 9 – stops CD playback
– erases a CD program
0 PROG – programs CD tracks
! DISPLAY – displays clock for a few second
during CD/Radio/AUX mode.
@ ALARM1/ALARM2
– sets, activates and deactivates alarm of
ALARM1/ALARM2
– switches off the active buzzer, radio or CD
alarm
# SLEEP
– switches on/off or adjusts timer options for
radio, CD playback or relaxation music.
– stops the active buzzer, radio or CD alarm
for 24 hours
$ LCD Display – shows the clock/ alarm time
or CD/radio information
% AUX – 3.5mm line-in for audio input
Power supply
1 Check if the power voltage as shown on the
type plate on the base of the set corresponds
to your local power supply. If it does not,
consult your dealer or service center.
2 Connect the power plug to the wall outlet.
The power supply is now switched on and
the numbers on the display shows 0:00.You
will need to set the correct time.
3 To disconnect the set from the power supply
completely, unplug from the wall outlet.
The type plate is located on the bottom
of the set.
For users in the U.K., please follow the
boxed instructions ‘Important notes...’ on
this sheet.
English Controls Power supply