Philips AJ 3280 - Manual (Page 4)

1 SLUMBER
– to activate radio for slumber
2 ALARM RESET
– to stop the active alarm for 24 hours
3 SET CONTROL
– RUN
To return to clock time display after
setting clock/alarm times
– ALARM 1
To adjust/review ALARM 1
– ALARM 2
To adjust/review ALARM 2
– TIME SET
To adjust clock time
– 7, 4 (fast up, slow down)
To adjust both the hours and minutes for
the clock and alarm times
4 SLUMBER OFF / REPEAT ALARM
– to switch off slumber
– to stop the active alarm for a 6 minute
period
5 Display
– with alarm indicators
6 TUNING
– to tune to radio stations
7 BAND
– to select FM-MW (LW) band
8 VOLUME
– to adjust the sound level
9 RADIO
– to switch radio mode ON/OFF
0 ALARM 2:
– OFF
to switch off alarm 2
– RAD (io)
to activate radio for alarm 2 setting
– BUZ (zer)
to activate buzzer for alarm 2 setting
! ALARM 1:
– OFF
to switch off alarm 1
– RAD (io)
to activate radio for alarm 1 setting
– BUZ (zer)
to activate buzzer for alarm 1 setting
@ Mains lead
– for AC mains supply
# Battery compartment
– for power battery backup
$ Pigtail aerial - for FM reception
1. Check if the mains voltage as shown on the
type plate on the base of the set corresponds
to your local mains supply.
2. Connect the mains plug into the wall socket.
The mains supply is now switched on and the
numbers on the display will start to flash. You
will need to set the correct time.
3. To disconnect the set from the mains
completely, withdraw the mains plug from the
wall socket.
For users in the U.K.: please follow the
instructions on page 2.
You can use the clock radio solely as a radio.
1. Set the RADIO switch to ON.
2. Select your waveband using the BAND switch.
3. Use TUNING to find your radio station.
4. Adjust the sound with the VOLUME control.
5. To turn off the radio, set the RADIO switch to
OFF.
To improve radio reception
– For
MW (or LW), the set is provided with a
built-in aerial which to function best should be
placed on a non-metallic surface e.g. wood,
plastic. Direct the MW aerial by adjusting the
position of your clock radio.
– For FM reception extend the pigtail aerial at
the back of the set completely to obtain
optimum reception.
FM/MW (LW) RADIO
MAINS CONNECTION
BACK PANEL See fig. 2
FRONT PANELS See fig. 1
CONTROLS INSTALLATION RADIO
4
English
AJ3280/00 page 4