Philips AJ 3280 - Manual (Page 6)

• If, however, you do not press SLUMBER
OFF /REPEAT ALARM again, the alarm will
sound for 59 minutes before turning itself off.
Your alarm time setting will then
automatically enter the ALARM RESET mode
to sound at the same time next day.
Switching off the alarm completely
• Before or during the set alarm goes off, push
the ALARM (1 or 2) switch to the OFF position.
– The alarm indicator will disappear from the
display.
The clock radio has a built-in timer device called
the SLUMBER, which enables the radio to be
automatically switched off after 59 minutes; this
allows you to lie back, listen and fall asleep.
SLUMBER ON
1. Set the RADIO switch to the OFF position.
2. Set your slumber time by pressing on the
SLUMBER button. Keep your finger on the
button and the display will begin to count
down from 59 to 00 minutes.
3. Release the button as soon as the required
slumber time is reached.
SLUMBER OFF
You can switch off the radio before the slumber
time has elapsed:
– To cancel the SLUMBER function, press
SLUMBER OFF /REPEAT ALARM.
Notes:
– The slumber function does not affect the
alarm setting (s).
– If during SLUMBER you have turned down the
volume and you have an alarm set in radio
mode, make sure you have adjusted the
volume loud enough to wake you up the next
day.
– If you do not intend to use the clock radio for
a long time, disconnect the set by removing
the plug from the wall socket. The battery
should also be removed to prevent chemical
leakage which will damage your set.
– To clean your set from fingerprints, dust and
dirt, use a clean and soft damp cloth or
chamois leather. Do not use cleaning products
which contain benzene, thinner etc. as these
may harm the housing.
– When a power failure occurs, the complete
clock radio will be switched off.
– As soon as the mains supply returns, the
numbers on the display will start to flash. This
indicates that you must set the correct time on
the clock.
– To retain the clock time and the set alarm time
(s) in the event of a power failure or
disconnection, insert a 9 volt battery, type
6F22
(not supplied) into the battery
compartment: this will act as a power back
up. However, the time will not be illuminated
on the clock display. Operation of the alarm(s)
and radio are also excluded.
For clarity, the battery back up is used to
retain the set clock and alarm time (s) only.
As soon as the mains supply returns, the
display will indicate the correct time.
• Before inserting the battery, connect the
mains plug to the wall socket.
• Insert a battery into the battery compartment.
– Replace the battery once a year or as often as
necessary.
Batteries contain chemical substances, so
they should be disposed of properly
POWER BREAKDOWN BACKUP
MAINTENANCE
SLUMBER
ALARM /SLUMBERING ADDITIONAL
6
English
AJ3280/00 page 6