Philips VR670B/58 - Manual (Page 34)

30
3
Enter the entire ShowView number. This number is up to 9 digits long
and can be found next to the start time of the TV programme in your
TV listings magazine.
e.g. 5-312-4 or 5 312 4
Enter 53124 for the ShowView-number.
If you make a mistake, you can clear your instructions with CLEAR
(CL)
.
SHOWVIEW
SHOWVIEW NUMBER REP.
53124---- èONCE p
________________________________
REP.pSELECT
STOREpOK
TIMER LISTpTIMER
Selecting onetime/daily/weekly recordings
Using SELECT , select from the following options:
'ONCE': Recording once
'MO-FR': Repeated daily recordings (Monday to Friday)
'WEEK.': Repeated weekly recordings (every week on the same day)
4
Confirm with OK .
TIMER
VPS
DATE REP. PROG. START PDC END
21 MO-FR 01 20:00 ] 21:30
________________________________
REP.pSELECT
STOREpOK
aThe following message appears on the screen: 'SELECT PROG.
NR.'
b The programme number of the TV channel has not yet been assigned to
the ShowView number. Using the number buttons 0-9 on the remote
control, select the corresponding programme number (name) of the TV
channel and confirm with
OK .
aThe following message appears on the screen: 'SHOWVIEW NUMBER
NOT VALID'
b The entered ShowView number is incorrect. Correct your instructions or
end with MENU .
b Check the time/date (see chapter 'Installing your video', section 'Setting the
time and date').
aThe following message appears on the screen: 'MO-FR
PROGRAMMING NOT POSSIBLE FOR WEEKEND'
b A daily recording was entered for the wrong day. Daily programming can
only be used for recordings to be made from Monday to Friday.
5
The decoded data appears after confirmation. You can go back to
change
the data. Select the corresponding input field using
SqP or QSr . Change the data with P ;q , P =r or
with the number buttons 0-9 .
Switching on 'VPS/PDC' in the 'START' input field
Select the 'START' input field using SqP . Using SELECT switch on
'VPS/PDC' (']' lights up). If you press SELECT again, you will switch
'VPS/PDC' off (']' goes out).
6
When all informations are correctly, confirm with OK . The
programming information is stored in a TIMER block.
7
Insert a cassette with an intact security tab (unprotected).
Programming a recording (TIMER)