Philips VR670B/58 - Manual (Page 37)

33
7
Switch off with STANDBY/ON m .
The programmed recording will only function when the video
recorder is switched off with STANDBY/ON m .
If any of the TIMER blocks are in use, ' k ' will light up on the video
recorder display.
Problem solving for programmed
recordings
PROBLEM SOLUTION
The video recorder
does not react b While a programmed recording is being made, you cannot operate your video recorder manually.
If you want to cancel the programmed recording, press STANDBY/ON m .
'SWITCH TO
STANDBY- TIMER
RECORDING' flashes on
the TV screen
b The video recorder was switched on several minutes before the start of a programmed recording.
Switch off the video recorder with STANDBY/ON m . A programmed recording (timer) will
only function if the video recorder is switched off.
A cassette was
automatically ejected
during recording
b The end of the tape was reached during recording.
Error message: 'NO
CASSETTE' '
k ' will
flash in the video
recorder display
b No cassette was inserted. Insert a cassette and switch off the video recorder using
STANDBY/ON m .
The 'PROTECTED
CASSETTE' error
message appears
briefly on the screen
then the cassette is
ejected
b A cassette was inserted with the security tab removed. Undo the erase protection (chapter
'Manual Recording', section 'Preventing accidental erasing of cassettes') or insert a different
cassette.
Error message: 'ALL
TIMERS OCCUPIED'
b If this error message appears after pressing TIMER k , then all TIMER blocks are already
programmed. No more recordings can be programmed. If you want to clear or check a
programmed recording (TIMER block), select it with P ;q or P =r .
The 'DATA ERROR'
message appears on
the screen
b The data for the recording could not be transferred. Please check date, start time and end time
of the programmed recording.
ENGLISH
Programming a recording (TIMER)