Precor Strength-Training Fitness Equiptment S3-19 - Manual (Page 18)

S3.19 Assembly and Maintenance Guide
page 18
1 2 3 4 5 6
6. Install Hi/Lo Pulley Assembly
Note: Ask for assistance to move the Hi/Lo Pulley
Assembly and align the mounting holes.
A. Attach the Hi/Lo Pulley Assembly to the Rear
Crossbar using
three 1¼-inch hex head bolts
three flat washers
three spring washers
three locknuts
Wrench tighten.
B. Attach the Floor Plate using
two ¾-inch buttonhead bolts
two locknuts
Wrench tighten using a 6mm hex key.
C. Attach the Crossbrace to the Top Beam using
two 4-inch hex head bolts
four radius washers
two locknuts
D. Attach the Crossbrace to the Hi/Lo Pulley using
one 2-inch hex head bolt
one washer
one locknut
Wrench tighten all three fasteners that secure the
Crossbrace.
A
B
C D
2 - 4" bolts
4 - radius washers
2 - locknuts
3 - 1¼" bolts
3 - washers
3 - spring washers
3 - locknuts
2 - ¾" buttonhead bolts
2 - locknuts
Floor Plate
1 - 2" bolt
1 - washer
1 - locknut
Rear
Crossbar
Hi/Lo Pulley Assembly
Crossbrace