Precor Strength-Training Fitness Equiptment S3-19 - Manual (Page 32)

S3.19 Assembly and Maintenance Guide
page 32
1 2 3 4 5 6
Cable Adjustments and Maintenance, continued
1. Cable Tension
If you experience any cable problems, take the following
steps to reduce tension on the cables:
A. Remove the Weight Pin and set it aside.
B. If the Leg Press is attached, place the Support Arm
in the upright (non-extended) position.
C. Check that the Press Arm rests lightly on the
Bumper Pad and is positioned so it causes minimal
tension in the cable. If necessary, rotate the
Bumper Pad.
D. Adjust the threaded ends on the Single Floating
Pulleys so the amount showing is the same on all
both pulleys. Retighten the jam nuts.
Note: You may need to loosen the jam nuts before
making adjustments.
E. Adjust the Weight Stack threaded end. Retighten
the jam nuts.
CAUTION: For safety reasons, always make sure
to turn the screw three to four full turns
so that the threads are engaged inside the
Selector Stem or Floating Pulleys before
tightening the jam nuts.
F. Replace the Weight Pin into the Weight Stack.
A
B
Leg Press Support Arm
in upright position.
C
D
E
F
D