Panasonic AW-PH400P - Manual (Page 20)

Indoor Pan/Tilt Head AW-PH400
20
Specifications
Genlock input: BNC
Black burst or composite video signal
Prompter input
(PROMPTER IN): BNC
Through output to PROMPTER connector
Prompter output
(PROMPTER OUT): D-SUB 15-pin
Camera video output
VIDEO: BNC, 75-ohm output
Y: BNC, 75-ohm output
Pr/C: BNC, 75-ohm output
Pb: BNC, 75-ohm output
SDI: BNC
Camera, pan/tilt head control: RJ45, RS-485, pan/tilt head control signal output
RP/IP Connecting cable: 10BASE-T straight cable (equivalent to UTP category 5),
max. 500 meters
Functions/performance: Maximum load-bearing capacity: 17.6 lbs (8 kg)
Tilt range: 300 degrees (approx. ±150 degrees)
The tilt range is limited to 190 degrees by the initial setting of the AW-RP400. To move
beyond 190 degrees, change the AW-RP400 setting.
The tilt range is subject to restrictions depending on the cable and lens of camera to be
mounted on pan/tilt head.
Pan range: 400 degrees (approx. ±200 degrees)
Maximum operating speed: 90 degrees/sec.
(Maximum operating speed with prompter mounted: 30 degrees/sec.)
Repeatability: ±30”
Noise level: Less than NC30 (at less than 30 degrees/sec.)
Ambient operating temperature: 32°F to 113°F (0°C to +45°C)
Storage temperature: –4°F to 140°F (–20°C to +60°C)
Ambient operating humidity: 30% to 90% (no condensation)
Dimensions (W ! H ! D): 12-3/8” ! 21” ! 7-3/8” (315 ! 534 ! 188 mm)
Weight: Approx. 22.5 lbs (10.2 kg)
Finish: AV ivory paint (color resembling Munsell 7.9Y6.8/0.8)
Weight and Dimensions indicated above are approximate.
Specifications are subject to change without notice.
Supply voltage: AC 120 V, 60 Hz
Power consumption: 145 W
1
indicates safety information.