Patton electronic IM2RC/F - Manual (Page 2)

TABLE OF CONTENTS
Section Page
1.0 Warranty Information .............................................................2
1.1 Radio and TV Interference
1.2 CE Notice
1.3 Service Information
2.0 General Information ...............................................................4
2.1 Product Features
2.2 General Product Description
3.0 Configuration .........................................................................5
3.1 Configuring the IM2RC/F Hardware Switches
3.2 Connecting the Interface Driver Board
4.0 Installation .............................................................................9
4.1 The Model 1000R16 Rack Chassis
4.2 Installing the Rear IM2RC/F Card and Front Function Card
4.3 Making Interface Connections
5.0 Operation .............................................................................14
5.1 Typical Application
5.2 Operating Instructions
Appendix A - Specifications ........................................................15
Appendix B - Factory Replacement Parts and Accessories .......16
Appendix C - 120 Ohm G.703 Inteface Pin Assignment.............17
Appendix D - Line Interface Assignment ....................................18
1
1.0 WARRANTY INFORMATION
Patton Electronics warrants all Model IM2RC/F components to
be free from defects, and will—at our option—repair or replace the
product should it fail within one year from the first date of shipment.
This warranty is limited to defects in workmanship or materials,
and does not cover customer damage, abuse or unauthorized
modification. If this product fails or does not perform as warranted,
your sole recourse shall be repair or replacement as described above.
Under no condition shall
Patton Electronics be liable for any damages
incurred by the use of this product. These damages include, but are
not limited to, the following: lost profits, lost savings and incidental or
consequential damages arising from the use of or inability to use this
product.
Patton Electronics specifically disclaims all other warranties,
expressed or implied, and the installation or use of this product shall be
deemed an acceptance of these terms by the user.
1.1 RADIO AND TV INTERFERENCE
The Model IM2RC/F generates and uses radio frequency energy,
and if not installed and used properly—that is, in strict accordance with
the manufacturer's instructions—may cause interference to radio and
television reception. The Model IM2RC/F has been tested and found to
comply with the limits for a Class A computing device in accordance
with the specifications in Subpart J of Part 15 of FCC rules, which are
designed to provide reasonable protection from such interference in a
commercial installation. However, there is no guarantee that
interference will not occur in a particular installation. If the Model
IM2RC/F does cause interference to radio or television reception,
which can be determined by disconnecting the unit, the user is
encouraged to try to correct the interference by one or more of the
following measures: moving the computing equipment away from the
receiver, re-orienting the receiving antenna and/or plugging the
receiving equipment into a different AC outlet (such that the computing
equipment and receiver are on different branches). In the event the
user detects intermittent or continuous product malfunction due to
nearby high power transmitting radio frequency equipment, the user is
strongly advised to use only data cables with an external outer shield
bonded to a metal or metalized connector at both ends. Shielded
cables must be used on the network connection to satisfy compliance
with the Electromagnetic Compatibility (EMC) directive.
2