Panasonic 999000 User Manual
Page 16
10. To tension the rewind spring, first guide the rope through the notch on the edge of the rope
rotor and form a loop, use it to turn the rope rotor 4–5 times counterclockwise.
11. Then hold the rope rotor tight, pull out the twisted rope and untangle it.
12. Release the rope rotor, slowly let go of the starter rope so that it is wound up on the rope rotor.
13. Refit the flywheel/starter cover (1) and screw in the four screws (2).
4. Replacing pawl (Ref. Fig. 13):
The pawl functions as a link between the rope rotor and the c
(by engaging and disengaging the starter cup) and needs to be
replaced if damaged.
rankshaft
1. Unscrew the screws (2) on the flywheel/starter cover (1) and
remove the cover from the engine unit.
2. Remove the spring clip (8), then remove the damaged
pawl (9).
3. Install a new pawl.
4. Refit the spring clip (8) and the flywheel/starter cover (1) in
succession.
Fig. 13
15