Panasonic CQ-VD7200U - Manual (Page 35)

73
CQ-VD7200U
64
E
N
G
L
I
S
H
Speaker
(Black)
(Black/green stripe)
Hide-away Unit
(Rear)
Note: See next page for hide-away unit
electrical connection.
Note: Supplied only for operational sound such as a beep.
Do not use it for a center speaker.
Caution: Do not use the supplied speaker for some
other units or components.
72
CQ-VD7200U
63
E
N
G
L
I
S
H
Panasonic
ACC
BATTERY 5A
VIDEO-CONT
SIDE BRAKE
REVERSE
SPEAKER
!
@
Wiring Diagram
Electrical Connections
Accessory used for wiring
(Green/yellow stripe)
@9 Display Unit/Hide-away Unit Connecting Cord
(Blue/yellow stripe)
(Violet/white stripe)
(Red)
(Black)
(Yellow)
(Black)
(Black/green stripe)
Side Brake (Parking Brake) Connection
Lead
Be sure to wire the side brake (parking
brake) for safety and preventing accidents.
(
a page 76)
Reverse Lead
When connecting the rear view camera,
use the reverse lead. (
a page 81)
Power Lead
To ACC power, +12 V DC.
Battery Lead
To the car battery, continuous +12 V DC.
Ground Lead
To a clean, bare metallic part of the car
chassis.
Note: Use a Reverse Extension Cord @7 if
needed.
(Resistor 220 Ω )
(Fuse 5 A)
Speaker Lead
Display Unit
(Rear)
@6 Power Connector
RGB Input Cord
To the RGB Connector of the Panasonic car
navigation system (available in future).
Video Control Lead
To the Video Control Lead of the
Panasonic car navigation system
(available in future).
No. Item Q'ty
@6 Power Connector (for display unit) 1
@7
Reverse Extension Cord
(for rear view camera)
1
@8 Clip Connector 1
@9
Display Unit/Hide-away Unit
Connecting Cord
1
No. Item Q'ty
#0 Power Connector (for hide-away unit) 1
#1 Ground Lead 1
#2 Radio Antenna Extension Cord 1
Digital Audio Output
Connector (optical)
(
a page 82)
Caution: Do not
insert the power
connector into the
unit until the wiring
is completed.
Notes:
¡To prevent damage to the unit, be sure to follow the connection diagram below.
¡Be sure to fully plug in the connectors. Secure them with clamps and tape.
¡When game machines are connected, the picture may be unstable.
¡When removing the Power Connector @6 and Display Unit/Hide-away Unit Connecting Cord @9 , be sure to press the clip.
¡All other installation methods require the use of dedicated metal fittings. Consult with a qualified servicing engineer or your
dealer if other methods are required.
Cautions:
¡This unit is designed for use in a car having a 12-volt negative ground battery system.
¡Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and keep
cable terminals free from touching any metal parts.
¡Note that if your car has a driving computer or a navigation computer, disconnecting the cable from the battery may
clear the memory.
¡Install the cords avoiding the spots where the temperature should be extremely high.