Panasonic CQ-VD7200U - Manual (Page 44)

Maintenance
Your product is designed and manufactured to ensure a minimum of maintenance. Use a dry soft cloth for routine exterior
cleaning. Never use benzine, thinner or other solvents.
Product Servicing
If the suggestions in the charts do not solve the problem, we recommend that you take it to your nearest authorized
Panasonic Servicenter. The product should be serviced only by a qualified technician.
Replacing the Fuse
Use fuses of the same specified rating (5 A for display unit, 15 A for hide-away unit). Using different substitutes or fuses with
higher rating, or connecting the product directly without a fuse, could cause fire or damage to this unit.
If the replacement fuse fails, contact your nearest Panasonic Servicenter for service.
If the Unit Begins to Malfunction...
Reset switch
Insert a hard, slender stick into the hole and push the switch.
Important
Push the switch only when the unit fails to operate with any buttons. (Stored settings and adjustments are not cleared.)
If the unit fails to return to normal condition, call the nearest Panasonic Servicenter and ask for repairs.
MENU MODE NAVI
NAVIGATION ASPECT
P·MODE POWER
ASP ENTER
CQ-VD7200U
7 INCH WIDE COLOR LCD TV / DVD - VIDEO / RECEIVER
DISC
TRACK/ CHANNEL
RESET
Hide-away Unit
Reset switch
Display Unit
Notes:
¡We recommend that you press both of the reset switches on the Display Unit and the Hide-away Unit one by one in any
order.
¡If the ID-CODE has been already set, you will be asked to enter the ID-CODE right after the unit is restarted.
90 91
81
E
N
G
L
I
S
H
82
E
N
G
L
I
S
H
CQ-VD7200U CQ-VD7200U
Troubleshooting
(continued)
- E4 -
Error Display Messages
- E3 -
NO DISC
Display Cause/Step
- E1 -
- E2 -
■ CD/MP3/DVD/Video CD/CD Changer
PAL/NTSC ERROR
REGION ERROR
NO MAGAZINE
Notes:
¡There may be cases when the disc numbers affected by an error are displayed before E1 and E2.
¡Displays and the steps to be taken for errors vary in part from changer to changer. For details, refer to the Operating
Instructions for the changer used.
Disc is dirty, or is upside down.
a Check disc.
Disc has scratches.
a Check disc.
No operation by some cause.
a Press [u]. If failure persists, press the reset switch. (Press the reset
switch in the CD changer). If normal operation is not restored, call the
store where you purchased the unit or the nearest Panasonic
Servicenter.
The type of the file that is selected is not supported.
a Check disc.
No disc is in the player.
a Insert disc into the disc slot.
No magazine is in the changer.
a Load the changer with CD-loaded magazine.
An attempt was made to play a PAL disc.
a Press [u] and check the disc.
An attempt was made to play a disc with a region number other than “1” or
“ALL”.
a Press [u] and check the disc.