Panasonic C9801W - Manual (Page 6)

12 CQ-C9901W/C9801W 13
English
CQ-C9901W/C9801W
Power on
Press [SRC] (PWR: POWER).
Notes:
¡ The opening screen appears. You can overwrite the
opening screen (moving picture) with new one. (
a
page 36)
¡ When the power is switched on for the first time, a
demonstration message appears on the display. Press
[DISP] to change to regular mode. (
a page 10)
Power off
Hold down [SRC] (PWR: POWER) for 2
sec. or more and release it.
Note: The ending screen appears. You can overwrite the
ending screen (moving picture) with new one. (
a page
36)
General
This chapter explains how to turn on or off the power, how to adjust the volume, etc.
You can remove the face
plate to prevent it from
being stolen.
Removing
1
Turn off the power ( a page 12)
2
Press [ ] (Release).
(The face plate disengages
with a click when it is
removed.)
The face plate automati-
cally closes in 5 sec-
onds if it is open or tilt-
ed.
Note: The power is automatically turned off while
the unit is active.
3
Put the face plate in the case.
Mounting
1
Slide the left side of the face plate in
place.
2
Press the right end of the face plate
until “click” is heard.
Caution
¡ It is recommended to remove or mount the face
plate when the plate is at the closed position.
Do not remove or mount the face plate when the
plate is in motion.
¡ This face plate is not waterproof. Do not expose it to
water or excessive moisture.
¡ Do not remove the face plate while driving your car.
¡ Do not place the face plate on the dashboard or
nearby areas where the temperature rises to high
levels.
¡ Do not touch the contacts on the face plate or on the
main unit, since this may result in poor electrical
contacts.
¡ If dirt or other foreign substances get on the con-
tacts, wipe them off with clean and dry cloth.
¡ To avoid damaging the face plate, do not push it
down or place objects on it while it is open.
Open/Eject
Press [ ] (OPEN).
When a disc is already loaded, the disc will automatically
be ejected.
Close
Press [ ] (OPEN).
Tilt
The display angle changes among 4 levels as follows
every time you hold down [
] (TILT) for 1 sec. or
more and release.
Note: The last selected
angle is maintained even
after turning off the power.
Notes:
¡ The volume level can be set independently for each
source. (For radio, one volume setting for AM, one
volume setting for all FMs)
¡ The volume is not adjustable while an error appears
on the monitor or the external mute function is
enabled. (
a page 42)
q Up
w Down
Setting Range: 0 to 40
Default: 18
Volume off (down)
Press [ ] (MUTE).
Cancel
Press [ ] (MUTE) again.
Note: Volume-down range can be specified. ( a page
34)
Power On/off
(PWR: POWER)
Face Plate Motion (Open/Close, T
ilt)
(OPEN/CLOSE, TILT)
V
olume Adjustment
(VOLUME)
Temporar
y V
olume Off (Down)
MUTE (ATT: ATTENUATION)
Caution
¡ To avoid damaging the face plate, do not push it
down or place objects on it while it is open.
¡ Do not pinch your finger or hand in the face plate.
¡ Do not insert foreign objects into the disc slots.
¡ For the following cases, the face plate automatical-
ly closes. Use caution not to catch your finger.
¡ After a lapse of 20 seconds
¡ When a disc is inserted
¡ When the face plate is removed ( a page 12)
¡ Five seconds after turning off the power or
turning the key to ACC OFF.
TILT 1
TILT 2
TILT 3
OPEN
TILT OFF
Face Plate Removing/Mounting
(ANTI-THEFT)
SRC CS SRC
SRC CS
SRC CS
General