PVI Industries Water Heater - Manual

QuickDraw ®
BOILER WATER
POLYSHIELD
®
POLYMER-LINED
INSTANTANEOUS PACKAGED WATER HEATER
Standard Features and Equipment
Pressure Vessel
•
POLYSHIELD® polymer-lined tank
•
Tank lining is certified as seamless and holiday-free by wet electrode method ASTM D 5162
•
___ Single-wall or ____Double-wall copper u-tube heat exchanger
with nonferrous baffles, rods, and tube sheet(s)
•
Heat exchanger is ASME-code, rated for 150 psi and 300°F
•
Tank constructed to ASME code and stamped for 150 psi design pressure
• Nonferrous intra-tank circulator (1/7 hp, 120V, 1Ø, 60 Hz., 1.7 amp on model 10 P A-IW)
(not required on model 20 P A-IW)
(1/3 hp, 120V, 1Ø, 60 Hz., 8 amp on model 45 P A-IW)
•
Nonferrous, tank connections
•
Heavy-density tank insulation
•
Rust-proof, dent-resistant, PVC jacket
•
Floor stand
•
Drain valve
Temperature Controls and Safety Devices
•
Boiler water pump
•
Electronic pump controller
•
Immersion operating thermostat
•
Immersion, automatic-reset, temperature limiting device
•
NEMA-rated control enclosure
•
ASME-rated temperature and pressure relief valve (set at 210°F and 150 psi)
•
Outlet water temperature controlled to within ±5°F of set point
• On/off remote terminals for building energy management system
Optional Equipment
q
AGA-rated temperature and pressure relief valve (set at 210°F and 150 psi)
q Wall mounts
q Boiler water cutoff valve
q Gauge Package:
Tank temperature and pressure gauges
Boiler water temperature gauge
Manual-reset, immersion temperature limiting device
q Gauge and Redundant Safety Controls Package: (all of Gauge Package plus…)
Water flow switch for low water cutoff
Solenoid over-temperature tank purge valve
À See complete warranty for details
PV 6351 3/00
PVI INDUSTRIES, INC.
FORT WORTH, TEXAS 76111
(800) 784-8326
PVI reserves the right
to change the design
and specification without notice.