Pentair Pressure Side Pool Cleaner Legend II - Manual (Page 11)

LEGEND® II INSTALLATION MANUAL
III. Operation/Periodic Maintenance
A. Connecting/Disconnecting the
Legend
® II
Turn off pool pump. Then take the Wall Fitting and
twist lock the Wall Fitting clockwise into the Wall
Adapter. To disconnect the Legend
® II, unlock and
twist counter clockwise. The Wall Adapter should
remain in the pool wall.
B. Turning On/Off the Legend ® II
The Legend ® II operates off a filtration pump coming
from the equipment pad, and can be turned on or off
by merely turning on/off your pump time clock.
C. Cleaning the Sand & Silt Bag
Carefully unlock the debris bag from the vacuum tube
and open the Velcro
® Brand fastener at the top of
debris bag and dump debris.
If you have a lot of debris in your pool, especially
after a storm, you can run your Legend
® II in two
shorter cycles per day and empty the debris bag
between cycles.
Reconnect the debris bag to the vacuum tube.
Do NOT over turn.
If the Velcro ® Brand fastener on top of the debris bag
does not stay secure, rinse well, let it dry and clean
with a stiff brush.
A Helpful Hint: It is easier to empty the debris bag
when it is dry. A second bag may be used while the
full debris bag is drying.
It's best to empty the debris bag when it becomes
half full. The Legend
® II will have better performance
if the bag is not overloaded.
D. Periodic Maintenance
The following parts are wear items that should be
checked, maintained or replaced as needed. Wear
items are considered any working or moving part(s)
being worn due to the use of the cleaner. Wear items
are not covered under warranty.
1. Wall Fitting Screen
Inside the wall fitting is a filter screen that acts as a
secondary filter. This screen is to keep debris that is
passed by the pool filter out of the Legend
® II.
Running the Cleaner without the filter screen can
damage the Legend
® II and will void the warranty.
A continuous plugged or dirty screen is a sign of
problems in your pool filtration system and you need
to contact your local pool professional.
To clean the filter screen, pull the screen out from
inside the Wall Fitting and rinse thoroughly and push
back inside the wall fitting.
Whenever cleaning, back washing or repairing filter,
remove the wall fitting and flush out the dedicated
line before using the Legend
® II.
7