Pentair Pressure Side Pool Cleaner Legend II - Manual (Page 5)

LEGEND® II INSTALLATION MANUAL
I. Introduction
A. Thank You for Choosing the
Legend ® II Pool Cleaner
Congratulations on the purchase of your new
automatic pool cleaner. The Legend
® II is designed
to give you years of dependable and efficient service.
With the Legend
® II, you and your family will spend
more time relaxing and enjoying your pool and less
time cleaning it.
The Legend ® II has been designed and built with time
proven features and patented innovations to create
an automatic pool cleaner that will give you years of
dependable service. The Legend
® II is built with pride
by people who care about the product using state of
the art materials and backed by a limited warranty
that protects against defects in parts and
construction.
Like any mechanical device, the Legend ® II
requires some preventative maintenance and the
replacement of certain working parts. We
recommend that you have your Legend
® II checked
annually. For best results have your Legend ® II
installed by a qualified swimming pool professional.
For pool owners with plumbing and mechanical
experience, installation instructions are included in
this manual.
Please put safety first! Be sure to take your
Legend
® II out of your pool and store it carefully in a
shaded area before anyone enters the pool.
B. What to Expect from the Legend ® II
When operating correctly, the Legend ® II will travel
randomly throughout the pool, vacuuming and
sweeping the bottom. The climbing ability of the
Legend
® II is dependent on the pools shape. It will
climb better in pools without sharp angles or curves
in the transition from the pool floor to the pool wall.
The Legend ® II comes equipped with a Wall Fitting
(Part# LXW22) that features a Twist Lock Automatic
Pressure Relief Valve. If the Legend
® II is receiving
too much water pressure to the unit, the relief valve
will automatically reduce water pressure.
Approximately every three minutes and 30 seconds
the Legend
® II will go into a back up mode. At this
time the Back Up Valve will pull the Legend ® II away
from problem areas.
Occasionally some vinyl pools have steps installed
so the unit may not climb and remains stationary until
the Back Up Valve pulls the unit away from the steps.
When this occurs you need to use the optional
Step Adapter (Part# EU13) to prevent wearing the
vinyl liner.
The Sweep Hose operates in a gentle sweeping
motion to prevent debris from becoming trapped in
hard to reach corners of the pool.
1